Peugeot 308 Key Fob Replacement

Peugeot's 308 could be catching on a bit however it's still attractive. It's not the most luxurious vehicle in its class, but it is an enjoyable and relaxing driving experience.

We get asked frequently at Coded Car Keys to replace peugeot key fobs. The following tips will help whether the problem is ongoing or intermittent.

Water Damage

If you accidentally drop your key fob in an eddy, or it gets wet while kayaking canoeing or rafting or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry, dry bag each time you go outside or peugeot 308 key fob Replacement engage in things that expose it to excessive amounts water.

It's also crucial to make sure that the fob is completely dried before you open it to use it again. If you detect any odors from the fob (such as industrial fluid or windshield washer fluid) it is a indicator that it is submerged.

A wet circuit may cause the battery's energy to drain or even explode. If you can get your keyfob 308 out of the water, turn the button side up and shake as much water out as you can prior to opening the casing. After you open it, take off the battery, and then clean the circuit board with a cotton swab dipped in 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could not function include the battery of your coin is dead problems with the receiver module, signal interference, or an electronic chip that is damaged. If none of these are the cause you can reset the system by disconnecting 12 Volt battery from the car for 15 mins.

Dead Coin Battery

Peugeot cars come with remote start that lets drivers start their car from an extended distance, which allows them to warm up or cool down the vehicle before they enter. This feature is extremely beneficial particularly during the cold winter months. However, sometimes the remote start system stops functioning due to a variety of reasons, like a dead coin battery.

The coin-shaped battery that is inside the key fob will last between two and four years depending on how often it is used, where it was purchased and how it is used. The date for use-by is typically written on the package or written in the manual.

If the key fob stops working after exposure to clean tap water it is recommended to take the battery off, clean the chip with a paper towel and isopropyl Alcohol, then dry it completely before replacing it. If exposed to soapy or salty water, the chip may be fried and you will have to replace the key fob completely.

If you're not sure whether the battery is damaged it is possible to check its voltage using an instrument connected to the plus and minus terminals. The voltage should range from 12-13 volts, but if it's lower, the battery should be replaced. If you want to, you can try to reset your on-board computer by disconnecting the battery with 12 volts for a couple of minutes, and reconnecting it in reverse order (positive cable first followed by negative). The engine should begin to run after this.

Faulty Receiver Module

If you're not receiving the "Key Detected" message on your dashboard, it's possible that your receiver module has developed a fault. It's the part that sends out a signal when your key fob activates. It also functions as an alarm and prevents the vehicle from starting without the correct key.

This could be due to a range of causes, such as water damage or simply ageing. If your Peugeot 308 key fob has been exposed to dirty tap water, as in the electronic chip inside the device will be damaged. In this situation you'll need to remove off the battery and clean it thoroughly using isopropyl or electronic cleaner. When the battery is clean, you can try again.

If the problem persists it is a good idea to visit the local Peugeot expert or locksmith. They can use an instrument for diagnosing to identify the issue and then fix it.

It can be a stressful experience to lose your Peugeot car key. However, a reputable auto locksmith can address the issue in just a few minutes. They can cut a new key and program it to your vehicle, making sure you're back out on the road in the shortest time possible. Find a locksmith near you.

Faulty Electronic Chip

The electronic chip that is in your peugeot car key replacement cost 308 key fob is an vital component of the remote control system. If the chip is damaged, you could be unable to start your car or receive a message stating "anti-theft". If this occurs, the only option to fix the issue is to obtain a new key. Professional auto locksmiths are able to provide this service in the shortest time.

The chip in the chip of your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or any other cause. If your Peugeot key fob has been exposed dirty or soapy water, it needs to be cleaned right away. You can clean the electronic component using an absorbent paper towel that has been soaked in isopropyl Alcohol. Then, you need to allow the battery to completely dry.

Radio interference can cause a key fob to stop functioning. This could be due to other devices use the same frequency as your peugeot boxer key keyfob. It could be caused by bad conditions or objects within the vicinity of the vehicle. If you encounter this issue it is recommended to visit an Peugeot dealership.

The Peugeot Key Fob 207/308 is very delicate and requires particular care. It is imperative not to throw or drop the key fob. If you lose something, try to locate it as quickly as you can. You can reset all the on-board computers by disconnecting the battery that is 12 volts for a few minutes. Remove the negative cable before the positive.