Reasons Why Your Nissan Qashqai Key Fob Won't Work

The Qashqai's greater dimensions give it an SUV-like feel. Its 19-inch alloy wheels on Ti and STL versions can also be firm. The front tyres could lose grip on rough surfaces and its CVT could occasionally exhibit wrist-flexing torque steer.

This is typically caused by a dead battery that can be replaced in just a few minutes. Make sure the replacement battery is the same voltage, size and specifications.

Water Damage

Water damage is among the most common causes for the Nissan keyfob to display the "key ID incorrect" message. The rubber seals on the key fob protect the chip's electronic components, however prolonged exposure to moisture can cause it to malfunction correctly. It is common to observe this happen if your key fob has been dropped into the water or in a swimming pool. However, it can occur when it becomes wet due to showers or soapy hands.

If your key fob is exposed to water for a lengthy period of time, it could need to be cleaned using isopropyl alcohol, or electronic cleaner. Alternatively, it might need to be taken to an expert to repair or replace it.

If your key fob has to be replaced, it is an easy procedure. Make sure you have the right multipack (CR2032, 3V). Then, you can open the back and front cases using an abrasive screwdriver. Remove the metal clips, then remove the old battery and then replace it. Reassemble the fob and Nissan Qashqai key fob replace the mechanical key. Verify that it is working properly. If it does not then you'll need to take it to a Nissan dealer or professional auto locksmith to repair the chip. The chip isn't usually damaged by water, so it should not be too expensive.

Dead Coin Battery

Another common reason your nissan qashqai replacement key Qashqai key fob might not work is that the battery inside is dead. They last for three to five years, however they are prone to failure over time when the fob is frequently dropped. You can replace the battery but be sure to use the same voltage and same size as the previous. If you use a different battery it may cause the key to have an invalid key ID which will prevent it from pairing with your vehicle.

The most effective method to replace the coin battery on a Nissan Qashqai key fob is by opening the fob with the small screwdriver with a flat-head. The screwdriver needs to be inserted into a small notch on the bottom of your key fob. The screwdriver should be gently twisted to divide the two halves. Remove the old CR2025 battery and replace it with a brand new one, making note of the position of the old one in the fob.

Before you put the new battery into place be sure that there is no dirt or water damage on the terminals. If so clean the terminals using some isopropyl ethanol. Make sure that the pole cables are properly connected. They should be connected to the positive and negative poles of your battery.

Diagnostics of a fault

If your Nissan Qashqai key fob stops working after exposure to clean rain or tap water it could be a sign of an internal chip problem. A battery change won't solve the issue, and you'll need to buy an entirely new key fob. If you dropped the key fob on the ground and it stopped working immediately, this is most likely due to the damage to the internal chip. You can usually get the key fob back to work again if you remove and clean the chip using paper towel and isopropyl alcohol and then insert it back into.

Key ID Incorrect is a typical error that you can see on the dashboard of your vehicle. This means that the vehicle is unable to recognize the key fob and will not allow it to start the engine. This issue can be caused by numerous ways, including water damage, problems undetectable in the circuitry of the key fob or RFID interference.

The key fob will not function when the 12 volt batteries are not working or provide sufficient electric current. This will affect the remote keyless system as well as central locking of your nissan key fob replacement Qashqai, as well as stopping you from starting the engine using the key fob (if equipped with Intelligent Key). If you are unable to lock or unlock the door by hand you must check the batteries on your key fob to be sure they are in good shape. Try re-inserting the battery to reset the transmitter.

Reprogramming

If the key fob is not been submerged in salt water, it should be able to return to life after a quick rinse with clean water. You may also try cleaning the electronic chip using isopropyl ethanol or an electronic cleaner. If none of these methods work, you may have to replace the key fob.

If your Nissan Intelligent Key is still not working, it could be an issue with the connection between it and your car. To reconnect it, start by turning the key in the ignition without starting the car. Continue this process until the hazard lights flash twice. Then, turn off your vehicle and remove the key.

Open the fob compartment of your vehicle's fob compartment. It is typically located in a door jamb, on the handle for the driver's door or under an armrest. Find the small button labeled "program" and press it. When the process is complete, you should hear the sound of a chime.

It's time to put your Intelligent Key to the test. Use all the buttons on the key while standing a distance from the car. If the lights flash and the horn sound it means the key has successfully connected to the Nissan. You can also test it near the Nissan.