Peugeot 308 Key Fob Replacement

Peugeot's 308 may be a bit old but it's eye-catching. It might not be the plushest car in its class - a Ford Focus or Volkswagen Golf will isolate you even better from road imperfections, however, it's a comfortable and civilised driving experience.

We often get asked at Coded Car Keys to replace peugeot key fobs. These tips can assist whether the issue is intermittent, or constant.

Water Damage

If you accidentally drop your key fob in the puddle, or it gets wet while kayaking canoeing, rafting, or canyoning it is likely to be damaged by water. The best way to prevent this from happening is to keep it in a dry bag when you're outdoors or performing activities where the fob could be exposed to excessive amounts of water.

It's also crucial to make sure the fob has completely dried out before you open it and use it again. If you notice any odors emanating from the fob like an industrial smell or a sour taste like windshield washer fluid, it's another sign that it's been submerged in water.

A circuit board that is wet could cause the battery to lose its energy or even explode. If you can get the 308 keyfob from the water it is best to turn the button side up and shake as much water out as you can prior to opening the casing. After opening it, remove the battery and wipe the circuit board with the help of a cotton swab that has been dipped in 90-percent isopropyl alcohol.

Other reasons your Peugeot 308 remote entry keyless system might not work could be due to a dead coin-cell battery or receiver module issue signal interference, or a faulty chip. If none of the above are the reason, you may try resetting the system by removing the battery that is 12 volts for about 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote start system that allows drivers to start their car from an extended distance, peugeot car key which allows them to warm up or cool down the car prior to entering. This feature is very beneficial particularly in cold winter months. However, there are times when the remote start system ceases working due to a variety of causes, such as an unresponsive coin battery.

A coin-shaped battery that is found inside the key fob will last a time of two to four years, based on how often it is used and where it's purchased. The date of use is usually printed on the package or marked in the manual.

If the key fob stopped functioning after exposure to water that is clean then you must take the battery off, clean the chip with a paper towel and isopropyl ethanol, then dry it completely before replacing it. In case of exposure to salty or soapy water, the chip could be fried and you will need to replace the key fob in total.

If you're unsure if the battery is in good condition You can test its voltage with an instrument set to the vehicle's voltage range and connected to the terminals for minus and plus. If the voltage is lower than 12-13 volts, you need to replace the battery. You can also reset your computer in the onboard computer by disconnection and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now begin.

Faulty Receiver Module

If you're not getting the "Key Detected" message on your dashboard, then it's possible that the receiver module has developed a fault. It's the component that sends an indication to the car when the key fob is activated, it also acts as an immobiliser. It also stops it from starting unless the key that you want to use is present.

This could be due to a number of causes including water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the electronic chip located inside is damaged. In this case you will need to remove it and thoroughly clean it using isopropyl or electronic cleaner. Once it's dry you can put the battery back in and test it again.

If the issue continues to persist, it is a good idea to see a local Peugeot expert or locksmith. They will be able to utilize a diagnostic tool to identify the issue and repair it for you.

It is stressful to lose your Peugeot car key. However, a reputable auto locksmith can resolve the issue in only a few minutes. They can cut a new key and peugeot car key program it to your vehicle, ensuring that you're back on the road again as quickly as possible. Click here to find locksmiths near you.

Electronic chip malfunctions

The electronic chip that is in your Peugeot 308 key fob is an crucial component of the remote control system. If it gets damaged, your car may not start, or you could receive a message that reads "anti-theft active". If this occurs, the only way to fix the problem is to purchase a new key. Luckily, auto locksmiths who are professionals can provide the service in the shortest amount of time.

The chip inside the chip of your Peugeot 308 key fob can be damaged by sweat, water damage dirt, or any other cause. If your Peugeot 308 key fob is exposed to soapy water, you must take it to the cleaners immediately. You can use a paper towel and isopropyl alcohol to clean the electronic component. The battery must then be allowed to fully dry.

Radio interference can cause a key fob to stop working. This is usually caused by other devices operate on the same frequencies as your Peugeot keyfob. It could also be caused by bad weather or objects around the vehicle. If you have this issue, it is best to visit an Peugeot dealership.

The Peugeot key fob 207/308 is extremely delicate and requires a lot of attention. It is important not to drop or throw the key fob. If you lose it, try to locate it as soon as you can. You can reset all on-board computers by disconnecting the 12 volt battery for a few minutes. Disconnect the negative cable before the positive.