Peugeot 308 Key Fob Replacement

Peugeot's 308 might be catching on a little but it's still attractive. It's not the most luxurious car in its class, but it's an enjoyable and relaxing driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is constant or intermittent the following tips will assist.

Water Damage

If you accidentally drop your key fob into an eddy, or it gets wet while kayaking, canoeing or rafting or canyoning, the fob is likely to be damaged by water. Keep your key fob in a dry bag whenever you go outside or engage in things that expose it to excessive amounts water.

You should also ensure that the fob is completely dry before opening it up and using it again. If you detect any smells emanating from the fob such as an industrial-type liquid smell or the scent of windshield washer fluid, it's another sign that it's been submerged in water.

A circuit board that's damp can cause the battery to discharge its charge or even explode. If you can get your keyfob 308 from the water it is best to turn the button side up and shake as much water as you can before opening the casing. Take the battery out, and then clean the circuit board with a cotton swab that has been dipped in 90-percent alcohol.

Other reasons your Peugeot 308 remote keyless entry system that you use to enter your home may not function include a dead coin battery, receiver module issues signal interference, a faulty electronic chip. If none of these are the reason, you may try resetting the system by disconnecting the battery with 12 volts for about 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with a remote-start system that allows the driver to start the car from a distance, warming up or cooling down the vehicle prior to stepping inside. This feature is extremely useful, especially in the cold winter months. But sometimes, the remote stop system stops working due to a variety of reasons, such as a dead coin battery.

The coin-shaped battery located inside the key fob could last between two and four years depending on how often it's used, where it was purchased, and the way it is utilized. The date for use-by is typically written on the package or marked in the manual.

If the key fob is no longer working after being exposed to water that is clean, remove the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then dry the chip completely before replacing. In the event of exposure to salty or soapy water, the chip might be fried and you will require replacing the key fob in total.

If you're not sure that the battery is not working properly You can test the voltage with a multimeter that is set to the vehicle's voltage range and connected to the minus and plus terminals. The voltage should range from 12-13 volts but if it's lower, the battery must be replaced. If you want to, you can try to reset the onboard computer by disconnecting the battery with 12 volts for a few minutes and reconnecting it in reverse order (positive cable first followed by negative). The engine should then start.

Faulty Receiver Module

If you don't see "Key Detected" It could be that your receiver module is faulty. It's the component that sends an alert to the car when your key fob is activated it also acts as an immobiliser, and stops it from starting unless the correct key is used.

The cause could be various causes, such as water damage or simply the aging process. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the chip that is located inside the device will be damaged. In this case you will need to remove it and clean it thoroughly using isopropyl or an electronic cleaner. Once the battery is dry, you can try again.

If the problem persists then it's a good option to consult an area Peugeot specialist or locksmith. They will be able to make use of a diagnostic device to identify the issue and fix it.

It can be a stressful experience to lose your Peugeot car key. A professional auto locksmith can solve the issue in minutes. They can program your vehicle and cut a fresh, working key for you. Click here to find a local locksmith near you.

A malfunctioning electronic chip

The electronic chip in the Peugeot 308 key fob is an vital component of the remote control system. If the chip is damaged, you may encounter issues starting your car or receive a message stating "anti-theft". In this scenario, the only solution is to replace the key. Auto locksmiths who are professionals are able to provide this fastest possible time.

The chip in the chip of your Peugeot 308 key fob can be damaged due to sweat, water damage dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, it is recommended to clean it right away. You can wipe the electronic component with a paper towel soaked in isopropyl Alcohol. The battery should then be allowed to dry completely.

Radio interference can cause a key fob to stop working. This could be caused by other devices operating at the same frequency as your peugeot 307 key replacement key fob. It can also be caused by weather conditions or objects in the vicinity of the vehicle. It is recommended to see a Peugeot dealer in the event of this problem.

The Peugeot key fob 207/308 is very delicate and requires a lot of attention. You should not drop it or throw it around. If you lose it, try to locate it as soon as you can. You can reset the on-board computer by disconnecting the battery for a few minutes. Unplug the negative cable prior to the positive.