Peugeot 308 Key Fob Replacement

Peugeot's 308 may be catching on a bit however, it's still attractive. It's not the plushest car in its class - an Ford Focus or Volkswagen Golf will shield you from sloping surfaces - however, it's a comfortable and a civilized drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. The following tips will aid whether the issue is constant or intermittent.

Water Damage

If you accidentally drop your key fob into an eddy, or it gets wet while kayaking, canoeing or rafting or canyoning it is likely to be damaged by water. Keep your key fob in a dry container whenever you go outside or engage in activities that could expose it to excessive water.

It's also important to make sure the fob has completely dried before you open it and use it again. If you detect any smells coming from the fob, such as an industrial-type liquid smell or the scent of windshield washer fluid, this is another indication that it's submerged in water.

A circuit board that is wet could cause the battery to dump its charge or even explode. If you can pull your keyfob 308 out of the water you need to turn the button side up and shake as much water as you can prior to opening the casing. Remove the battery, Peugeot 308 key fob then wipe the circuit board down using a cotton swab that has been submerged in 90 percent alcohol.

Other causes why your Peugeot 308 remote entry keyless system may not work could be due to a dead coin-cell battery or receiver module issues signal interference or a damaged chip. If none of the above is the cause you can reset the system by removing the 12 Volt battery from the car for 15 mins.

Dead Coin Battery

peugeot key cars are equipped with a remote-start feature that allows the driver to start the car from afar by warming up or cooling down the car prior to entering. This feature is extremely useful, especially during cold winter months. However, there are times when the remote start system stops operating due to a range of reasons, such as the battery in the coin is dead.

The coin-shaped battery located inside the key fob can last between two and four months, depending on how frequently it is used, the location it was purchased and how it is utilized. The date for use-by is typically written on the package or written in the manual.

If the key fob has stopped working after exposure to clean tap water, you should remove the battery, then clean the electronic chip using a paper towel and isopropyl ethanol, then dry it thoroughly before replacing it. If exposed to salty or soapy water, the chip may be damaged and you'll need to replace the key fob in total.

If you're not sure that the battery is not working properly you can check its voltage using a multimeter set to the car's voltage range, Peugeot 308 key Fob and connect it to the terminals for minus and plus. The voltage should be between 12-13 volts but if it is lower, the battery needs to be replaced. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should now begin.

Faulty Receiver Module

If you don't get the "Key Detected" It could be that your receiver module is faulty. It's the component which sends out an alert when the key fob is activated. It also acts as an alarm that stops the car from starting if you don't have the correct key.

This can be due to several causes, such as water damage or just aging. If your Peugeot 308 key fob has been exposed to dirty tap water, for instance the chip that is located inside is damaged. In this scenario, you'll need to remove it and clean it thoroughly using isopropyl or an electronic cleaner. When the battery is dry, you can try again.

If the issue persists, it is a good idea to visit an area Peugeot expert or locksmith. They can employ an instrument for diagnosing to pinpoint the problem and repair it.

The loss of your Peugeot car keys can be a stressful experience. A qualified auto locksmith will be able to solve the problem within minutes. They can cut a brand new key and program it to your vehicle, so you're back out on the road as fast as you can. Click here to find a local locksmith near you.

Faulty Electronic Chip

The chip inside the Peugeot 308 key fob is a very vital component of the remote control system. If it becomes damaged, your car may not start or you may receive a message saying "anti-theft active". In this instance the only option is to replace the key. Auto locksmiths with experience can provide this fastest possible time.

The chip in your Peugeot 308 key fob can become faulty due to water damage, sweat dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, you should clean it immediately. You can use a paper towel and isopropyl alcohol for cleaning the electronic component. After that, you should let the battery dry completely.

Radio interference can cause the key fob to stop functioning. This can happen when other devices operate on the same frequencies as your Peugeot keyfob. This can be caused by problems with the environment or objects close to the vehicle. It is recommended to visit a Peugeot dealer if you encounter this problem.

The Peugeot 207/308 key fob is extremely delicate and requires care. You should not drop it or throw it around. If you lose it, try to locate it as quickly as possible. You can reset the onboard computer by disconnecting the battery for a few minutes. Disconnect the negative cable prior to the positive.