Peugeot 308 Key Fob Replacement

Peugeot's 308 might be somewhat old-fashioned, but it is still attractive. It's not the most luxurious vehicle in its class, but it's an enjoyable and relaxing driving experience.

We get asked frequently at Coded Car Keys to replace peugeot key fobs. The following tips will help whether the problem is persistent or intermittent.

Water Damage

When you accidentally leave your fob in a puddle or splash it with water while kayaking, swimming canoeing, rafting or canyoning, it's more likely to suffer water damage. The best way to prevent this from happening is to keep it in a dry bag when you're outside or performing activities where the fob could be exposed to a lot of water.

It's also crucial to ensure sure that the fob is completely dried out before you open the fob and then use it. If you detect any smells coming from the fob, like an industrial liquid smell or windshield washer fluid, this is another sign that it's been submerged in water.

A wet circuit can cause the battery's charge to drain or even explode. If you're able to fish the 308 key fob of the water body it was stuck in turn the button upside down and shake out as much water as you can before opening the case. Once you have opened it, remove the battery and wipe the circuit board with an abrasive soaked in 90 percent isopropyl alcohol.

Other causes why your Peugeot 308 remote entry keyless system may not work include a dead coin cell battery or receiver module issue signal interference, or a malfunctioning chip. If none of the above are the cause, you can try resetting the system by disconnecting the battery that is 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start technology which allows drivers to start their car from an extended distance, which allows them to warm up or cool down the car before they enter. This feature is extremely helpful, especially during cold winter months. But sometimes, the remote start system ceases operating due to a range of reasons, such as an unresponsive coin battery.

A coin-shaped battery found inside the key fob will last a time of between two and four years, depending on how often it is used and where it's purchased. The date of use will be printed on the packaging or in the user manual.

If the key fob is no longer functioning after being exposed to clean tapwater, take out the battery and clean the electronic chip with the help of a paper towel that has been soaked with isopropyl ethanol. Then, peugeot 308 key Fob replacement dry the chip thoroughly before replacing it. If the key fob has been exposed to soapy or salty water, it may have caused the chip to be damaged. You will need to replace it.

If you are not sure the battery is faulty it is possible to test its voltage with a multimeter set to your vehicle's voltage range and connected to the plus and minus terminals. The voltage should be around 12-13 volts, but if it's lower, then the battery needs to be replaced. You can also reset the computer onboard by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should now begin.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, it's possible that the receiver module has created a fault. It's the part that transmits an alarm to the car when the key fob is activated, that also acts as an immobiliser, and stops it from starting until the correct key is used.

This could be due to a number of factors including water damage or simply getting old. If the electronic chip inside your Peugeot 308 keyfob is damaged by dirty tap water, it could be because the keyfob was in contact with it. In this instance, you'll need to take it out and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and test it again.

If the issue is not resolved, peugeot 308 key fob replacement it is recommended that you visit an area Peugeot expert or locksmith. They can use the diagnostic tool to pinpoint the problem and repair it.

It is stressful to lose your Peugeot car key. A professional auto locksmith can solve the problem within minutes. They can program your vehicle and cut a new working key for you. Click here to find a local locksmith near you.

Faulty Electronic Chip

The electronic chip in the Peugeot 308 key fob plays a vital part in the remote control system. If it becomes damaged, your car might not start, or you could get a message saying "anti-theft active". If this occurs, the only way to fix the issue is to obtain a new key. Auto locksmiths who are professionals are able to offer the fastest possible time.

The chip inside the chip of your peugeot 207 key 308 key fob can fail due to water damage, sweat dirt, or other reasons. If your Peugeot key fob has been exposed soapy or dirty water, it needs to be cleaned promptly. You can employ a paper towel as well as isopropyl alcohol for cleaning the electronic component. After that, you should let the battery dry completely.

Radio interference can cause the key fob to cease working. This could be caused by other devices operating at the same frequency as your Peugeot key fob. It could also be caused by bad weather or objects around the vehicle. If you experience this problem, it is best to visit a Peugeot dealership.

The Peugeot key fob 207/308 is very delicate and requires special attention. It should not be dropped or throw it around. If you lose something, try to locate it as soon as possible. You can reset the onboard computer by disconnecting the battery for a few minutes. Make sure you disconnect the negative cable first before connecting the positive.