Fiat 500 Replacement Key Fob

It's possible to change the battery if your 500 remote key fob is not working. If you do replace the battery but it is still not working then the issue is likely to be elsewhere.

United Locksmith specializes in the production of new keys for classic cars. We have the tools and spare parts required for this type of service.

Dead Coin Battery

The most frequent reason why your Fiat 500 key fob will not lock or unlock the doors is a dead battery. The coin cell battery in the key fob will drain quickly if you don't use it often enough. If your remote began to show signs of weakening such as a loss in range, and then stopped working completely, the battery is probably dead.

The battery in the key fob is held in place with metal clips that retain it. If the clips are not tight, they can create problems with contact that can prevent your remote from receiving power. Use a flathead screwdriver break open the retaining clip and remove the old battery. Make sure to use a battery with the same voltage, size, and specifications as the original.

The key fob can be damaged or corroded by exposure to water. Even a quick shower in soapy water can harm the electronic chip within. It is recommended to keep your key fob in a dry area.

Water Damage

If your key fob isn't operating correctly, it could be caused by water damage. The rubber seals on key fobs keep them from getting damaged by a tiny splash or drizzle of water. However, it's essential to keep the car keys away from the washing machine, the ocean and pool.

The key fob is equipped with an electronic chip which sends an electronic message to the immobilizer of your car. The chip allows the 500 to be Locked keys in car boot fiat punto and started. If it gets wet, however it won't work.

If you want to check if your key fob is functioning, you can clean the internal electronics using isopropyl or an electronic cleaner. It is recommended to replace a key fob in the event that it has been submerged into salt water instead of trying to fix it yourself.

A replacement fob can cost you a little bit however it's much less expensive than paying to have your Fiat 500 towed to a dealership and fixed there! You could also do it yourself by following just a few steps. Be sure to have the correct type of battery before you attempt to open your key fob. There are step-by-step directions for any key fob in your car online.

Faulty Chip

The chip that is contained in the key fob communicates with your vehicle's immobiliser to ensure that the vehicle is only capable of starting when the correct key is used. If the chip is damaged, or corrupted in any way it will not start.

Water damage or a dead cell battery are the two most frequently cited reasons for fiat punto replacement key the chip being damaged. It is recommended to leave the job to a professional locksmith who can repair the chip quickly and at a reasonable price.

If your key fob ceases to function after exposure to clean tap water or rain, remove the battery and wipe down the electronic component with a towel to ensure it is fully dry before putting it back into. If the key fob does not work, there's the possibility that it has a fried component and needs to be replaced.

Some people will turn to their dealer when in need of a new Fiat key fob, however this can be a very costly alternative. United Locksmith is the best option if you need your Fiat key fob replaced at a reasonable cost. We have the equipment and know-how necessary to repair your Fiat key fob in a quick and professional manner.

Faulty Receiver Module

Fiat key fobs send signals of up 50 feet to the vehicle, which can unlock and close the doors (and start the vehicle in case of automatic transmissions). There are a variety of reasons why a fob could stop working. This can be caused by a dead coin-battery or water damage, worn out buttons an issue with the receiver, signal interference, or an issue with the chip.

If the fob was located in the pocket that has been subject to severe trauma (such as being dropped onto a hard floor or being washed in the washing machine) the fob may not be able to communicate with the Body Control Module (BCM) of the vehicle. The BCM is a security system which will only accept signals from genuine original keys.

It is necessary to replace the fob in case this occurs. A professional locksmith is able to handle every aspect of the key replacement process and even program a new one for your 500. They can even provide an identical fob that functions the same as the original (and costs only one-third of what it would cost).