Peugeot 308 Key Fob Replacement

Peugeot's 308 is somewhat old-fashioned however it's still striking. It might not be the most luxurious car in its class but an Ford Focus or Volkswagen Golf will shield you from surface imperfections - but it's a relaxed and pleasant drive.

We get asked frequently at Coded Car Keys to replace peugeot key fobs. These tips can assist whether the issue is persistent or intermittent.

Water Damage

When you accidentally leave your key fob in a pool or get it wet during kayaking, swimming, canoeing, rafting or canyoning, it's more likely to suffer water damage. Keep your key fob in a dry container whenever you go outdoors or do activities that expose it to excessive water.

It's also crucial to make sure the fob has completely dried out before you open it to use it again. If you detect any odors emanating from the fob (such as industrial liquid or windshield washer fluid) This is a further indicator that it is submerged.

A circuit board that's damp can cause the battery to dump its energy or even explode. If you're able fish your key fob 308 out of the water in which it was stuck in, flip the button side down and shake it out as much water as possible before opening the case. Remove the battery, then wipe the circuit board clean with a cotton swab, which has been dipped into 90-percent alcohol.

Other reasons why your Peugeot 308 remote keyless entry system might stop working include the battery of your coin is dead or receiver module issues, signal interference, or a faulty electronic chip. If none of the above are the issue it is possible to reset the system by disconnecting the 12 Volt battery from the car for 15 minutes.

Dead Coin Battery

Peugeot cars come with a remote-start system that allows the driver to start the car from a distance and then warm up or cool down the vehicle prior to stepping inside. This feature is extremely beneficial, especially during cold winter months. The remote start system may stop working for a variety reasons, including a dead coin-battery.

The coin-shaped battery located inside the key fob could last between two and four years, based on how frequently it is used, where it was purchased, and the way it is used. The date of use is typically found on the packaging or peugeot Key fob listed in the instruction manual.

If the key fob stopped functioning after exposure to clean tap water, you should take the battery off, clean the chip with a paper towel and isopropyl alcohol, then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it could have caused the chip to be damaged. It is necessary to replace it.

If you're not sure the battery is in good condition you can check its voltage with a multimeter that is set to the car's voltage range, and connect it to the minus and plus terminals. If the voltage is lower than 12-13 volts then you must replace the battery. Alternately, you could try to reset the on-board computer by disconnecting the 12 volt battery for a couple of minutes, and reconnecting it in reverse order (positive cable first, then negative). The engine should be able to start after this.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, then it's possible that the receiver module has been afflicted with a fault. It's the part that transmits an alarm to the car when your key fob is activated it also acts as an immobiliser. It stops it from starting unless the key that you want to use is present.

This could be due to a range of causes, such as water damage or simply aging. If your Peugeot 308 key fob was exposed to dirty tap water, like, the electronic chip inside is damaged. In this instance you'll have to take the unit apart and clean it thoroughly using isopropyl or electronic cleaner. Once it's dry, you can put the battery back in and try it again.

If the issue continues to persist, it is a good idea that you visit an area Peugeot expert or locksmith. They can utilize an instrument for diagnosing to identify the issue and then fix it.

It can be stressful to lose your Peugeot car key. A certified auto locksmith will be able to solve the problem within minutes. They can program your car and cut a new, functioning key for you. Click here to find locksmiths near you.

Faulty Electronic Chip

The electronic chip inside the Peugeot 308 key fob plays a vital part in the remote control system. If the chip is damaged, you may encounter issues starting your car or receive a message that says "anti-theft". If this occurs, the only way to fix the problem is to get a new key. Auto locksmiths with experience are able to provide the service in the shortest time.

The chip in your Peugeot replacement key fob 308's key fob could be damaged due to many reasons, such as water damage, sweat or dirt. If your Peugeot key fob has been exposed to dirty or soapy water, it needs to be cleaned as soon as possible. You can employ a paper towel as well as isopropyl alcohol for cleaning the electronic component. The battery should then be allowed to fully dry.

Sometimes keys may cease to function due to radio interference. This could be caused by other devices operating at the same frequency as your Peugeot key fob. It could be caused by bad conditions or objects in the vicinity of the vehicle. It is recommended to see a Peugeot dealer in the event of this issue.

The peugeot 3008 key fob 207/308 key fob is extremely delicate and requires special care. It is crucial not to drop or throw the key fob. If you lose something, try to find it as quickly as you can. You can reset all the on-board computers by disconnecting the 12 volt battery for a few minutes. Be sure to disconnect the negative cable first, and then the positive.