Peugeot 308 Key Fob Replacement

Peugeot's 308 might seem a little old but it's still eye-catching. It's not the most luxurious vehicle in its class, but it's an enjoyable and relaxing drive.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. Whether the problem is constant or intermittent the following suggestions should help.

Water Damage

If you leave your key fob in a pool or get it wet during kayaking, swimming, canoeing, rafting or canyoning, it's likely to sustain water damage. Keep your key fob in a dry, dry bag each time you go outdoors or do activities that expose it to large amounts of water.

It is also important to make sure that the fob is dry prior to opening it and using it again. If you detect any odors from the fob (such as industrial fluid or windshield washer fluid) This is a further indication that it's submerged.

A wet circuit could cause the battery's power to be depleted or even explode. If you're able fish the 308 key fob of the water in which it got stuck in it, flip the button side down and shake it out as much water as possible before opening the case. Remove the battery, then wipe the circuit board clean using a cotton swab which has been dipped into 90-percent alcohol.

Other reasons your Peugeot 308 remote entry keyless system might not function include a dead coin cell battery or receiver module issues signal interference or a faulty chip. If none of these is the cause, you can try resetting the system by disconnecting the 12 volt battery for about 15 minutes.

Dead Coin Battery

Peugeot cars come with remote start that allows drivers to start their car from some distance, which allows them to warm up or cool down the vehicle before they get in. This feature is extremely beneficial particularly during the cold winter months. The remote start system can cease to function for a variety reasons, such as the battery being dead.

The coin-shaped battery contained within the key fob may last between two and four months, depending on how frequently it is utilized, the place it was purchased, and the way it is used. The date for use-by is typically printed on the packaging or marked in the manual.

If the key fob stopped working after being exposed to water that is clean, remove the battery and clean the electronic chip with a paper towel soaked in isopropyl ethanol. Then dry the chip completely before replacing. If the key fob was exposed to soapy or salty water, it may have caused the chip to be damaged. You'll need to replace it.

If you're not sure whether the battery is defective, Woodspock.Com%2F you can check its voltage with a multimeter that is connected to both the minus and plus terminals. The voltage should range from 12-13 volts but if it's lower, the battery should be replaced. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should be able to start after this.

Faulty Receiver Module

If you're unable to see the "Key Detected" message on your dashboard, it's possible the receiver module has discovered a problem. It's the part that transmits an alert to the car when the key fob is activated which also acts as an immobiliser. It also stops it from starting until the correct key is in place.

This could be due to a range of reasons, including water damage or simply getting old. If your peugeot 207 key 308 key fob has been exposed dirty tap water, like the electronic chip located on the inside will be damaged. In this case you will need to take it out and thoroughly clean it with isopropyl or an electronic cleaner. Once it's dry you can put the battery back into the battery and try again.

If the problem persists it is a good idea to visit a local Peugeot expert or locksmith. They can utilize a diagnostic tool in order to pinpoint the issue and then fix it.

It can be a stressful experience to lose your Peugeot car key. However, a trained auto locksmith can solve the issue in just a few minutes. They can cut a brand new key and program it to your vehicle, ensuring that you're out on the road in the shortest amount of time. Click here to locate locksmiths near you.

Faulty Electronic Chip

The electronic chip that is in your peugeot 207 car key 308 key fob is a very important part of the remote control system. If it gets damaged, your car might not start or you might get a message saying "anti-theft active". If this happens, the only way to fix the issue is to purchase a new key. Professional auto locksmiths can provide this fastest possible time.

The chip in the chip of your Peugeot 308 key fob can be damaged due to water damage, sweat dirt, or other causes. If your Peugeot 308 key fob is exposed to soapy water, clean it right away. You can clean the electronic component with an absorbent paper towel that has been soaked in isopropyl Alcohol. The battery should be allowed to fully dry.

Radio interference can cause the key fob to stop working. This can be caused when other devices operate on the same frequencies as your Peugeot keyfob. It could also be caused by weather conditions or objects that are in the vicinity of the vehicle. It is recommended to visit a Peugeot dealer if you have this problem.

The Peugeot 207/308 key fob is extremely delicate and requires care. You should not drop it or throw it around. If you lose something, try to locate it as soon as possible. You can reset your on-board computer by disconnection of the battery for a couple of minutes. Disconnect the negative cable before the positive.