Peugeot 308 Key Fob Replacement

Peugeot's 308 might be getting on a bit but it's still attractive. It's not the most luxurious car in its class, peugeot 308 key Fob but it is a pleasant and peaceful driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. No matter if the issue is ongoing or continuous the following tips will assist.

Water Damage

If you accidentally drop your key fob in a puddle or get it wet while kayaking, swimming canoeing, rafting or peugeot 308 Key Fob canyoning, it's likely to sustain water damage. Keep your key fob in a dry container whenever you are outside or perform things that expose it to excessive amounts water.

It is also important to make sure that the fob is dry before opening it up and using it again. If you notice any odors emanating from the fob like an industrial smell or a sour taste like windshield washer fluid, this is another sign that it's been submerged in water.

A wet circuit board can cause the battery to dump its charge or even explode. If you can pull the 308 keyfob from the water, turn the button side up and shake as much water as you can before opening the casing. After you open it, take off the battery, and then clean the circuit board using an abrasive soaked in 90 percent isopropyl alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could fail to function include an empty coin battery problems with the receiver module, signal interference, or an electronic chip that is damaged. If none of these is the reason, you may try resetting the system by disconnecting the battery with 12 volts for about 15 minutes.

Dead Coin Battery

Peugeot cars are equipped with remote start that lets drivers start their vehicle from a distance, allowing them to warm up or cool down the vehicle before entering. This feature is extremely helpful, especially during winter's cold and chilly months. However, it is possible that the remote start system stops functioning due to a variety of reasons, like the battery in the coin is dead.

The coin-shaped battery that is inside the key fob can last between two and four years based on the frequency with which it is used, the location it was purchased, and the way it is used. The date of use will be printed on the packaging or in the user manual.

If the key fob stops working after exposure to water that is clean, you should take the battery off, clean the chip using a paper towel and isopropyl Alcohol, then dry it completely before replacing it. In case of exposure to soapy or salty water, the chip could be damaged and you'll require replacing the key fob altogether.

If you're not sure whether the battery is in good condition it is possible to check its voltage using a multimeter connected to both the terminals plus and minus. The voltage should read approximately 12 to 13 volts, however, if it reads lower, the battery must be replaced. You can also reset your onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first, then negative cable). The engine should then start after this.

Faulty Receiver Module

If you're not seeing the "Key Detected" message on your dashboard, it's possible the receiver module has created a fault. It's the component which sends out an alert when your key fob goes off. It also acts as an alarm, and stops the vehicle from starting without the correct key.

This could be caused by various causes, such as water damage or just getting old. If your Peugeot 308 key fob was exposed to dirty tap water, for instance the electronic chip located on the inside will be damaged. In this situation, you'll need to take it apart and clean it thoroughly with isopropyl alcohol or an electronic cleaner. Once it's dry, you can put the battery back in and try it again.

If the issue is not resolved, it is a good idea to see an area Peugeot expert or locksmith. They'll use a diagnostic tool to identify the problem and repair it for you.

It can be stressful to lose your Peugeot car key. However, a qualified auto locksmith can address the issue in a matter of minutes. They can cut a new key and programme it to your vehicle, so you can get back off the road as quickly as possible. Find the nearest locksmith.

Faulty Electronic Chip

The electronic chip in your Peugeot 308 key fob is an crucial component of the remote control system. If the chip is damaged, you could be unable to start your car or get a message saying "anti-theft". If this happens, the only way to fix the problem is to replace the key. Fortunately, auto locksmiths with experience can complete the task in the shortest amount of time.

The chip inside your Peugeot 308 key fob can fail due to sweat, water damage, dirt or other reasons. If your Peugeot 308 key fob has been exposed to soapy water, you should take it to the cleaners immediately. You can use a paper towel and isopropyl alcohol to wipe the electronic component. After that, you should allow the battery to dry completely.

Radio interference can cause a key fob to cease working. This can be caused when other devices operate on the same frequency as your Peugeot keyfob. It could be caused by unsafe conditions or objects that are close to the vehicle. It is recommended that you visit a peugeot key fob replacement dealer if you have this problem.

The Peugeot Key Fob 207/308 is delicate and needs particular care. You should not drop it or throw it around. If you lose it, try to locate it as quickly as you can. You can reset your on-board computer by disconnecting the battery for a couple of minutes. Be sure to disconnect the negative cable first, then the positive.