Fiat 500 Replacement Key Fob

It might be time to replace the battery if the 500 remote key fob isn't working. However, if you replace the battery but it continues to stop working then the issue may be elsewhere.

At United Locksmith, we specialize in making new keys for old cars. We have all the tools and accessories needed to provide this service.

Dead Coin Battery

A dead battery is the primary cause of your Fiat 500 keyfob not locking or unlocking the doors. The coin cell battery in the key fob will deplete quickly when you don't use it often enough. If your remote started to show signs of weakening like a loss of range, and then stopped working completely it is likely that the battery is dead.

Metal clips hold the battery securely on the key fob. If the clips aren't tight, they can cause contact problems that will prevent your remote from receiving power. Use a flathead screwdriver to open the retaining clips and remove the battery. Make sure you use a replacement with the same type of voltage, dimensions, and specification as the original battery.

The key fob could be damaged or corroded by exposure to water. Even a short bath in soapy water can damage the electronic chip inside. Keep your key fob dry.

Water Damage

Water damage could be the reason for your key fob not working properly. The rubber seals on key fobs protect them from being damaged by a slight drizzle or splash of water. However, it is crucial to keep the keys of your car away from the ocean, washing machine, and pool.

The key fob is equipped with an electronic chip that transmits a message to the immobilizer of your car. The chip is what allows the 500 to lock and start. If it gets wet, however it won't function.

You can clean the internal electronics of your key fob with isopropyl Alcohol or an electronic cleaner to see whether they're still working. It is recommended to replace a key fob if it has been submerged into salt water instead of trying to repair it yourself.

A replacement fob may cost you a few dollars but it's far less expensive than paying to have your Fiat 500 towed to a dealer and repaired there! You could also do it yourself by following a few simple steps. Make sure you have the right battery type before you attempt to open your key fob. You can find step-bystep directions for any car keyfob on the internet.

Faulty Chip

The chip that is contained in the key fob communicates with the vehicle's immobiliser to ensure that your car is only able to start when the correct key is inserted. If the chip is damaged or damaged the car will not start, no matter what you do.

A chip that is damaged can happen due to several reasons, but most commonly due to water damage or a dead battery. It is best to hand over the task to a professional locksmith who can replace the chip in a short time and at a a reasonable price.

If your key fob will not function after exposure to water that is clean from the tap or rain, fiat ducato remote key programming remove the battery. Wipe down the electronic component using a towel. If the key fob still does not work it's most likely to be a damaged chip and must be replaced.

Some people will turn to their dealer when they are in need of an entirely new Fiat key fob, however this could be a costly alternative. If you are looking for a low-cost solution to have your fiat keys ducato remote key programming - telegra.ph, key fob fixed Look no further than United Locksmith. We have the tools and expertise to repair your Fiat fob in a timely and professional manner.

Faulty Receiver Module

Fiat key fobs send an electronic signal to the vehicle, which will unlock and lock doors (and start the car for vehicles with an automatic transmission) up to 50 feet. There are many reasons why the fob may not function. This can be caused by a dead coin-battery water damage, worn out buttons as well as a receiver issue. signal interference, or an issue with the chip.

If the fob was in a pocket which has experienced extreme trauma, fiat ducato remote key programming like being dropped on hard floor or getting washed in a wash machine the fob may not be able to communicate with the car's Body Control Module (BCM). This is because the BCM is a secure system that can only accept signals from a genuine original key and not another.

If this is the case, then you have to replace your fob. A professional locksmith will manage the entire key replacement process including programming a new key to your 500. They can even give you a clone fob that works exactly the same way as the original (and costs less than the cost).