Peugeot 208 Key Replacement

Peugeot 208 key replacement is best left to auto locksmiths with experience who have the appropriate equipment and know-how. They can design and program keys faster and less expensive than dealers.

If your key fob stopped locking or unlocking your doors, it is likely due to a dead battery in the coin. However, there are many other reasons the key could be malfunctioning.

Dead Coin Battery

A dead coin battery can stop your Peugeot 208 from locking or unlocking, and will not allow you to start the engine. If this is the case, you'll have to make use of the backup starting procedure that's described in the owner's manual to your vehicle.

Another reason your 208 might not be starting is because the spark plugs are been damaged. The spark plugs are responsible for instigating the fuel which starts the engine. However they have a finite lifespan. If they aren't utilized enough to last, they'll eventually fail.

Luckily, there's an easy solution to this problem. The best solution is to measure the voltage of your car battery using a multimeter. If it's less than 11.5 Volts then you must replace it. If the battery is damaged it is crucial to clean its contacts. This can be done by lifting the rubber covers that protect both battery terminals and using wire brushes to clean any corroded areas of the battery. Then, you should reconnect the positive and negative pole cables.

Water Damage

If your 208 doesn't start and the battery isn't flat then you should check whether the spark plugs are functioning. It could be that they're dirty, which causes them not to spark. The spark plugs can be cleaned in a workshop.

Peugeot cars are equipped with a transponder key that works with the car's ignition system. This ensures that only a valid key is able to turn the engine. If the chip inside the Peugeot key is damaged, بالنقر هنا then it won't send the correct signal to the vehicle.

This is a typical issue that can occur due to water damage. This is particularly prevalent in colder climates where the vehicle might have been exposed to snow or rain. If this is the case, seek out a reputable auto locksmith who will have all of the tools and equipment needed to reprogram the new key. They will also have the latest technology and equipment required to create the Peugeot smart key. The process shouldn't take more than 15 minutes.

Faulty Battery Contacts

Peugeot replaced the old transponder chips with a new model that utilizes electronic components that are mounted on a circuit board. The new system works great when it's new, however the circuit boards begin to degrade with time and cease to function properly.

This could stop the immobiliser from working, so your vehicle won't start. Contact an Peugeot specialist or a locksmith if this is the situation.

A common problem is when the battery in the key fob begins to fail. This causes the blade of the key to stop feeding into your lock. A locksmith for cars can replace the battery and cut a fresh blade for you, this is usually a simple fix.

Faulty Receiver Module

It could be that the receiver module is faulty in the event that your Peugeot key fob fails to function after being dropped on the floor, exposed to a stormy rainstorm, or accidentally washed. The receiver is responsible for sending radio frequency signals to the on-board computer, which is responsible for [empty] controlling the centralized locking system of your peugeot boxer key vehicle.

The rubber seals on the key fob prevent water from reaching its electronic chip. However, prolonged exposure to water may be able to penetrate these seals and cause damage to the chip. Submerging the key fob into ocean water on the beach or throwing it into the pool could be particularly damaging due to the high salt content.

If your Peugeot spare key fob doesn't work then you'll have to get the module replaced. This is only done by an expert auto locksmith or Peugeot specialist. Unlike other cars, Peugeot keys are protected by an exclusive immobilizer system that requires the correct code for the start of the engine. This is the reason why you should only be able to trust a professional Peugeot locksmith to handle the task of designing and programming an appropriate replacement.

Computer with a problem on board

The computer on board of your Peugeot is responsible for a variety of systems inside your car, including power windows and airbags. When something goes wrong in these systems, it will typically show a code that identifies the issue. This code will be saved in the system until the problem is fixed. In most cases, this will require replacing the onboard computer.

The most common reason for the warning light for the airbag to turn on is corrosion or loose connections within the sensor. This can be caused by wear and tear, age or exposure to salt and moisture. It is essential to have this issue resolved as soon as possible, since a malfunctioning airbag can be dangerous in the event an accident.

If your Peugeot is showing a card that is not being detected error, then the key battery inside the key fob might be weak or dead. This will stop the key fob sending a signal that will disable the immobilizer on your vehicle. Try this by pressing the unlock key on the key fob and then trying to start your car. If it doesn't work the battery on the key must be replaced.