Peugeot 308 Key Fob Replacement

Peugeot's 308 might be getting on a little however it's still appealing. It's not the most luxurious car in its class, but it's an enjoyable and relaxing driving experience.

Here at Coded Car Keys we are often asked to replace peugeot 308 key fobs. If the issue is persistent or intermittent the following tips will assist.

Water Damage

If you accidentally drop your key fob in the puddle, or it gets wet while kayaking, canoeing, rafting, or canyoning it is likely to be damaged by water. Keep your key fob in a dry bag whenever you go outdoors or do activities that expose it to large amounts of water.

You should also make sure that the fob is completely dry before opening it up and using it again. If you detect any smells emanating from the fob like an industrial-like liquid smell or that of windshield washer fluid, it's another sign that it's been submerged in water.

A wet circuit can cause the battery's energy to drain or even explode. If you are able to get your keyfob 308 out of the water you need to turn the button side up and shake as much water out as you can prior to opening the casing. Remove the battery, then clean the circuit board using a cotton swab that has been dipped into 90-percent alcohol.

Other reasons why your Peugeot 308 remote keyless entry system could not function include an empty coin battery or receiver module issue, signal interference, or a faulty electronic chip. If none of the above are the issue, try resetting the system by disconnection of the battery at 12 volts for approximately 15 minutes.

Dead Coin Battery

Peugeot 208 Replacement Key Cost cars are equipped with a remote start system that allows the driver to start the car from afar while warming up or cooling down the car prior to entering. This feature is very beneficial particularly in cold winter months. Remote start systems may not function due to a variety of reasons, including the dead battery in the coin-battery.

A coin-shaped battery that is in the key fob can last for a period of two to four years, depending on how frequently it is used and where it's purchased. Its use-by date is typically printed on the packaging or written in the manual.

If the key fob has stopped working after exposure to water that is clean, you should take the battery off, clean the electronic chip with a paper towel and isopropyl Alcohol, then dry it completely before replacing it. If the key fob was exposed to soapy or salty water, it could have caused the chip to be damaged. It is recommended to replace it.

If you're not sure whether the battery is in good condition it is possible to check its voltage with a multimeter connected to both the terminals for plus and minus. If the voltage is lower than 12-13 volts, it is time to replace the battery. You can also reset the onboard computer by disconnecting and reconnecting the 12 volt batteries in reverse order. (positive cable first then negative cable). The engine should then start after this.

Faulty Receiver Module

If you don't see the "Key Detected", it could be the receiver module malfunctioning. It's the part that transmits the signal when your key fob activates. It also functions as an alarm and prevents the car from starting without the correct key.

It could be due to various causes, such as water damage or simply getting old. If your Peugeot 308 key fob has been exposed to dirty tap water, like the electronic chip on the inside will be damaged. In this case you will need to remove it and thoroughly clean it with isopropyl or an electronic cleaner. Once the battery is dry, you can try again.

If the issue isn't resolved the issue persists, it's a good idea to visit an area Peugeot specialist or locksmith. They'll be able to make use of a diagnostic device to identify the issue and repair it for you.

The loss of your Peugeot car keys can be an emotional experience. However, a reputable auto locksmith can solve the issue in a matter of minutes. They can program your vehicle and cut a new functioning key for you. Click here to locate the nearest locksmith.

Electronic chip malfunctions

The electronic chip that is in the peugeot 207 replacement key fob 308 key fob plays a vital part in the remote control system. If the chip is damaged, you could have problems starting your car or get a message saying "anti-theft". If this occurs, the only option to fix the issue is to replace the key. Professional auto locksmiths are able to provide the fastest possible time.

The chip in the key fob of your Peugeot 308 may fail due to a variety of reasons, such as sweat, water damage, or dirt. If your Peugeot key fob was exposed to dirty or soapy water, it should be cleaned immediately. You can wipe the electronic component using the help of a towel that is soaked in isopropyl Alcohol. The battery should then be allowed to fully dry.

Sometimes keys may not function due to radio interference. This could be caused by other devices operating at the same frequency as your Peugeot key fob. This can be caused by bad conditions or objects close to the vehicle. It is recommended to see a Peugeot dealer in the event of this problem.

The Peugeot 207/308 key fob is extremely delicate and requires special care. It is crucial not to throw or drop the key fob. If you lose it, try to find it as quickly as is possible. You can reset your on-board computer by disconnection of the battery for a couple of minutes. Make sure you disconnect the negative first, and then the positive.