Fiat 500 Replacement Key Fob

If your 500 remote key fob has stopped functioning, it could be time to replace the battery. However, Fiat Key Replacement Cost if you replace the battery and it doesn't work it may be elsewhere.

At United Locksmith, we specialize in making new keys for old cars. We have the tools and spare parts required for this service.

Dead Coin Battery

The most common reason why your Fiat 500 key fob will not unlock or lock the doors is a dead battery. The battery inside the key fob will drain quickly if you don't use it often enough. If your remote began to show signs of weakness like a loss of range and stopped working completely, the battery is probably dead.

Metal clips keep the battery in place within the key fob. If the clips are loose it can cause contact issues which will prevent your remote from receiving power. By using a small flathead screwdriver, pull the retaining clip open to remove the battery and insert a new one. Use a battery that has the same voltage, size and specification as the original.

Water exposure can also cause the key fob to corrode, or even become damaged. Even a short bath in warm, soapy water can damage the chip. It is recommended to keep your key fob in a dry location.

Water Damage

If your key fob isn't operating correctly, it could be due to water damage. The rubber seals on key fobs stop them from getting damaged by a tiny drizzle or splash of water. However, it's important to keep the car keys away from the ocean, washing machine, and the pool.

The key fob has an electronic chip that transmits a message to the immobilizer system of your car. The chip is what allows the 500 to be locked and started. If it gets wet, however it will not function.

If you're looking to determine if your key fob is still working you can clean the internal electronics using isopropyl or electronic cleaner. It is best to replace the key fob if it's submerged into salt water instead of trying to fix it yourself.

Although a replacement fob may cost you a little bit of money, it's much less expensive than paying for your fiat punto car key 500 to be towed to the dealer and repaired! You can also do it yourself with some simple steps. Make sure you have the correct battery type before you attempt to open your key fob. You can find step-bystep directions for every car keyfob online.

Faulty Chip

The chip that is contained in the key fob communicates with the car's immobiliser system to ensure your car is only capable of starting when the correct key is used. If the chip is damaged, or damaged in any way, your car will not start.

A chip that is damaged can happen due to a variety of reasons, but the most common reason is water damage or a dead battery. Whatever the reason, it is a good idea to leave this work to a locksmith as they will be able to replace the chip for you quickly and at a reasonable cost.

If your key fob will not function after being exposed to clean tap or rain water, remove the battery. Clean the electronic component using a paper towel. If the key fob still doesn't work it's likely to be an issue with the chip and is required to be replaced.

Some people will go to their dealer when they require a new fiat stilo key fob. But, this can be expensive. United Locksmith is the best option if you need your Fiat key fob replaced at a reasonable cost. We have the tools and expertise required to repair your Fiat key fob in a quick and professional way.

Faulty Receiver Module

Fiat key fobs send an electronic signal to the vehicle, which will unlock and close doors (and start the car for those with an automatic transmission) up to 50 feet. There are a few reasons why a fob could not function. This could be due to a dead battery water damage, worn-out buttons as well as a receiver issue. signal interference or a malfunctioning chip.

If the fob was located in a pocket which has suffered extreme trauma (such as being dropped on the hard floor or washed in the washer), it may not be able to connect with the Body Control Module (BCM) of the vehicle. This is because the BCM is a secure system that will only accept a signal from a genuine original key, and not from any other.

If this is the case, you will need to replace your fob. A locksmith professional can handle all aspects of the key replacement procedure as well as programming a new one for the 500. They can even give you a clone fob that works just like the original (and costs just a fraction of the cost).